Simulation design and characteristics analysis of dedicated dynamometer for cold roll-beating

DOI

10.2991/meic-14.2014.295How to use a DOI?

Keywords

Cold roll-beating;Dynamometer;Surface strain;Dynamic response; Calibration tests

Abstract

Cold roll-beating is a new advanced plastic forming technology, obtaining the forming force varying law is key to study the forming mechanism. Aiming at force measuring requirement in cold roll-beating forming process and the forming principle, a strain gage type dynamometer dedicated for cold roll-beating was designed, and a new type of elastomeric structure was proposed. ABAQUS software was used to simulate the static and dynamic characteristics of the structure, then the strain distribution rule of the elastomer surface sensitive position and the harmonic response characteristics and dynamic sensitivity of each gauging point were studied. Finally, experiment were carried out to calibrate the design dynamometer] and the results show that the dynamometer is suitable for measuring the cold roll-beating forming force.

Copyright

© 2014, the Authors. Published by Atlantis Press.

Open Access

This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

TY  - CONF
AU  - Ruiyuan Zhang
AU  - Yan Li
PY  - 2014/11
DA  - 2014/11
TI  - Simulation design and characteristics analysis of dedicated dynamometer for cold roll-beating
BT  - Proceedings of the 2014 International Conference on Mechatronics, Electronic, Industrial and Control Engineering
PB  - Atlantis Press
SP  - 1310
EP  - 1313
SN  - 2352-5401
UR  - https://doi.org/10.2991/meic-14.2014.295
DO  - 10.2991/meic-14.2014.295
ID  - Zhang2014/11
ER  -