Feasibility of Cladding Ti to Carbon Steel by Diffusion Bonding Followed by Hot-rolling
- https://doi.org/10.2991/icadme-15.2015.363How to use a DOI?
- Ti-clad steel; Diffusion bonding; Hot-rolling; Carbon steel; Heat treatment.
Ti was diffusion-bonded to a grade of carbon steel containing about 0.13 wt% C. The diffusion- bonded specimen was then hot-rolled to a final reduction in thickness of about 71 %. There were no delaminations during hot-rolling. The cross sectional microstructures of specimens before and after hot-rolling were characterised using scanning electron microscopy, energy dispersive spectroscopy and optical microscopy. It was proved that it is technically feasible to produce Ti-clad carbon steel plates using a process of diffusion bonding followed by hot-rolling. It was also demonstrated that normal heat treatment procedures involving quenching and tempering can be applied to Ti-clad carbon steels after hot-rolling. The bond strength of the claddings would be determined by the intermetallic compound phases formed at the interface between Ti and carbon steel, which could be optimised by adjusting the conditions of diffusion bonding and hot rolling processes.
- © 2015, the Authors. Published by Atlantis Press.
- Open Access
- This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).
Cite this article
TY - CONF AU - S.R. Ke AU - X.H. Xu AU - Z.D. Xiang PY - 2015/10 DA - 2015/10 TI - Feasibility of Cladding Ti to Carbon Steel by Diffusion Bonding Followed by Hot-rolling BT - Proceedings of the 5th International Conference on Advanced Design and Manufacturing Engineering PB - Atlantis Press SP - 1961 EP - 1965 SN - 2352-5401 UR - https://doi.org/10.2991/icadme-15.2015.363 DO - https://doi.org/10.2991/icadme-15.2015.363 ID - Ke2015/10 ER -