Design Analog Buffering on The multiplexer in RFID sensor tag with CMOS Technology 0.35 μm
Authors
Dyah Nur’ainingsih, Hamzah Afandi, Eri Prasetyo Wibowo, Busono Soerowirdjo
Corresponding Author
Dyah Nur’ainingsih
Available Online December 2015.
- DOI
- 10.2991/iceem-15.2015.5How to use a DOI?
- Keywords
- RFID sensor tags; multiplexer; water level sensor; temperature sensor; buffer
- Abstract
This paper describes the 'buffering system in the RFID sensor tags'. Buffer circuit function is used in the data selection as a buffer. Two-sensor output which is an analog signal by a multiplexer owns a possibility of a very low value. The buffer circuit is required to maintain the signal in order to prevent the dropped voltage. Its uses two inverters functioned as a non-inverting amplifier. The conclusion is that the buffering circuit is able to keep the voltage level by amplification of 1.
- Copyright
- © 2015, the Authors. Published by Atlantis Press.
- Open Access
- This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).
Cite this article
TY - CONF AU - Dyah Nur’ainingsih AU - Hamzah Afandi AU - Eri Prasetyo Wibowo AU - Busono Soerowirdjo PY - 2015/12 DA - 2015/12 TI - Design Analog Buffering on The multiplexer in RFID sensor tag with CMOS Technology 0.35 μm BT - Proceedings of the 2015 International Conference on Electrical, Electronics and Mechatronics PB - Atlantis Press SP - 18 EP - 21 SN - 2352-5401 UR - https://doi.org/10.2991/iceem-15.2015.5 DO - 10.2991/iceem-15.2015.5 ID - Nur’ainingsih2015/12 ER -