Proceedings of the 5th International Conference on Advanced Design and Manufacturing Engineering

Research on modeling of direct-injection gasoline engine turbocharging process based on AMESim software

Authors
Yuqiao Liu, Yongping Zhang
Corresponding Author
Yuqiao Liu
Available Online October 2015.
DOI
10.2991/icadme-15.2015.264How to use a DOI?
Keywords
V workflow,AMESim software,the offline model of the engine, the real-time model of the engine, the hardware-in-the-loop(HIL)
Abstract

In order to get the engine simulation model used for the development of control strategy, the offline model and real-time model of self-developed gasoline engine by FAW of direct-injection turbocharging were built based on AMESim software. The results of simulation were compared with that of actual engine test. At steady state condition of 3000r/min and full load, the error of air mass flow was 6.82%, the error of intake pressure was 3.6%, the error of BMEP was 0.097% and the error of fuel injection quantity was 0.3%. At transient state condition, the operating condition was reflected better by the simulation model of the engine and the transient simulation can be meet. The real-time model was simplified from offline simulation model which was successfully downloaded into the dSPACE simulator and the real-time verification on the model was finished. The Developing time of the control strategy was much shorter by simulation and the developing efficiency of electronic control systems was improved.

Copyright
© 2015, the Authors. Published by Atlantis Press.
Open Access
This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

Volume Title
Proceedings of the 5th International Conference on Advanced Design and Manufacturing Engineering
Series
Advances in Engineering Research
Publication Date
October 2015
ISBN
10.2991/icadme-15.2015.264
ISSN
2352-5401
DOI
10.2991/icadme-15.2015.264How to use a DOI?
Copyright
© 2015, the Authors. Published by Atlantis Press.
Open Access
This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Cite this article

TY  - CONF
AU  - Yuqiao Liu
AU  - Yongping Zhang
PY  - 2015/10
DA  - 2015/10
TI  - Research on modeling of direct-injection gasoline engine turbocharging process based on AMESim software
BT  - Proceedings of the 5th International Conference on Advanced Design and Manufacturing Engineering
PB  - Atlantis Press
SP  - 1430
EP  - 1433
SN  - 2352-5401
UR  - https://doi.org/10.2991/icadme-15.2015.264
DO  - 10.2991/icadme-15.2015.264
ID  - Liu2015/10
ER  -