Analysis and Research on Broken-off Driving Bevel Gear shaft of Automobile Axle
Available Online December 2015.
- 10.2991/jimet-15.2015.217How to use a DOI?
- automobile axle; driving bevel gear; broken; annealing
Based on the phenomenon of broken in the running process of the drive Gear shaft of Automobile Axle. It was found that the major site of broken for thread and spline connected region. The process of the gear shaft and the shaft material of the broken and the structure of thread and spline connected region were analyzed. Finally, it was found that the annealing time of thread and the structure of thread and spline connected region have some problems. The structure of thread and spline connected region was optimized. After improvement, it was not occurred the phenomenon of broken in the running process of the drive Gear shaft of Automobile Axle.
- © 2015, the Authors. Published by Atlantis Press.
- Open Access
- This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).
Cite this article
TY - CONF AU - Zhanlong Cao PY - 2015/12 DA - 2015/12 TI - Analysis and Research on Broken-off Driving Bevel Gear shaft of Automobile Axle BT - Proceedings of the 2015 Joint International Mechanical, Electronic and Information Technology Conference PB - Atlantis Press SP - 1151 EP - 1154 SN - 2352-538X UR - https://doi.org/10.2991/jimet-15.2015.217 DO - 10.2991/jimet-15.2015.217 ID - Cao2015/12 ER -