Proceedings of the AASRI International Conference on Industrial Electronics and Applications (2015)

Structure Optimization of Plastic Part Based on Moldflow

Authors
Wang Jie
Corresponding Author
Wang Jie
Available Online September 2015.
DOI
10.2991/iea-15.2015.15How to use a DOI?
Keywords
moldflow; optimize; warping deformation; plastic part
Abstract

Product structure and forming scheme of seeder’s typical part were analyzed and optimized in this topic, which affecting the warping deformation of plastic part using Moldflow software, ultimately the best solution was determined. The defects of mould design and plastic parts manufacturing injection moulding occur in the process can be effectively avoided using CAE software simulation. This simulation method can conduct mould structure optimization, and reduce repeat mould repair and the waste of mould trial energy, and improve rate of finished product.

Copyright
© 2015, the Authors. Published by Atlantis Press.
Open Access
This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

Volume Title
Proceedings of the AASRI International Conference on Industrial Electronics and Applications (2015)
Series
Advances in Engineering Research
Publication Date
September 2015
ISBN
978-94-62520-65-3
ISSN
2352-5401
DOI
10.2991/iea-15.2015.15How to use a DOI?
Copyright
© 2015, the Authors. Published by Atlantis Press.
Open Access
This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Cite this article

TY  - CONF
AU  - Wang Jie
PY  - 2015/09
DA  - 2015/09
TI  - Structure Optimization of Plastic Part Based on Moldflow
BT  - Proceedings of the AASRI International Conference on Industrial Electronics and Applications (2015)
PB  - Atlantis Press
SP  - 56
EP  - 58
SN  - 2352-5401
UR  - https://doi.org/10.2991/iea-15.2015.15
DO  - 10.2991/iea-15.2015.15
ID  - Jie2015/09
ER  -