An Automatic PH Equipment for Hydroponic System Using ATMEGA328P Microcontroller

DOI

10.2991/icoma-18.2019.79How to use a DOI?

Keywords

hydroponic, PH, sensor PH, microcontroller, control system

Abstract

The equipment of automatic pH control system has been introduced on the hydroponic with microcontroller ATmega328p. The aim of this research is to create a pH control system to reins water pH on hydroponic. This control system consists of hardware such as pH sensor, microcontroller Atmega328p, servo motor, water pump, LCD and software such as program algorithm. Hardware components were control by program algorithm. The pH value of hydroponic was monitored by pH sensor. The pH value has been read by the sensor used to servo control on taps the acid and alkaline shelter. The pH control uses range of 5.50 to 6.50 as set point. The results showed that pH sensor has the calibration average error of 2.28%. The pH control system showed servo 2 ”ON” and servo 1 ”OFF” when pH value < 5.50. This resulted that addition of an alkaline that increasing pH of the liquid. And than servo 1 and servo 2 “OFF” when pH value on 5.50 to 6.50. This shows that the pH of the liquid on set point condition. While the servo 1 “on” and servo 2 “OFF” when pH value > 6.50 which resulted the addition of acid liquid that resulting decrease on pH of the liquid.

Copyright

© 2019, the Authors. Published by Atlantis Press.

Open Access

This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

TY  - CONF
AU  - Dedi Nugroho
AU  - Priyono Priyono
AU  - Jatmiko Endro Suseno
PY  - 2019/10
DA  - 2019/10
TI  - An Automatic PH Equipment for Hydroponic System Using ATMEGA328P Microcontroller
BT  - Proceedings of the International Conference on Maritime and Archipelago (ICoMA 2018)
PB  - Atlantis Press
SP  - 373
EP  - 376
SN  - 2352-5401
UR  - https://doi.org/10.2991/icoma-18.2019.79
DO  - 10.2991/icoma-18.2019.79
ID  - Nugroho2019/10
ER  -