Topology Optimization Analysis of the Working Arm in the Slag Pot Carrier Based on Hyperworks
- DOI
- 10.2991/icmmct-16.2016.180How to use a DOI?
- Keywords
- Slag Pot Carrier, Working Arm, Hypermesh, Topology optimization.
- Abstract
Aiming at the problem of great mass and low material utilization coefficient of the working arm in a certain type of slag pot carrier, the static analysis and topology optimization analysis of the working arm were carried out. The finite element model of the working arm was established by using the pre-processing module of Hypermesh and its solution was solved. Post-processing was carried out by using the Hyperview module, and the stress- deformation diagram of the working arm under the working conditions of loading, transporting and pouring of slag pot were obtained. The Optistruct solver was employed to do the topology optimization and a reasonable improvement scheme is proposed based on the optimization result.
- Copyright
- © 2016, the Authors. Published by Atlantis Press.
- Open Access
- This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).
Cite this article
TY - CONF AU - Shihuai Shi AU - Ruifeng Guo AU - Yanhe Li PY - 2016/03 DA - 2016/03 TI - Topology Optimization Analysis of the Working Arm in the Slag Pot Carrier Based on Hyperworks BT - Proceedings of the 2016 4th International Conference on Machinery, Materials and Computing Technology PB - Atlantis Press SP - 906 EP - 909 SN - 2352-5401 UR - https://doi.org/10.2991/icmmct-16.2016.180 DO - 10.2991/icmmct-16.2016.180 ID - Shi2016/03 ER -