Fabrication and research on cone-shaped SOFCs by phase inversion technology
- DOI
- 10.2991/iccte-16.2016.229How to use a DOI?
- Keywords
- SOFCs, Cone-shaped, Phase inversion, Microstructure, Cell performance
- Abstract
Cone-shaped tubular anode substrates were prepared successfully by phase inversion technique. The effect of several kinds of organic additives on the microstructure development of NiO-YSZ anode support has been investigated. The scanning electron microscopy (SEM) results of NiO-YSZ anode supports show that the organic additives can greatly influence microstructure of the anode. Electrochemical testing shows that the single cell provides a maximum power output of 350mW/cm-2 at 800°C using PEG-1000 as additive. The correlation between the electrochemical performance of single cells and microstructure of the anodes had been analyzed in detail. In addition, a two-cell-stack was assembled by connecting cone-shaped anode-supported single cells in series. The chemical performance of the stack had also been tested.
- Copyright
- © 2016, the Authors. Published by Atlantis Press.
- Open Access
- This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).
Cite this article
TY - CONF AU - Handuo Wang AU - Cuixia Cai AU - Yuan Gao AU - Hailang Yu AU - Nisha Wang AU - Jiang Liu PY - 2016/01 DA - 2016/01 TI - Fabrication and research on cone-shaped SOFCs by phase inversion technology BT - Proceedings of the 2016 International Conference on Civil, Transportation and Environment PB - Atlantis Press SP - 1305 EP - 1312 SN - 2352-5401 UR - https://doi.org/10.2991/iccte-16.2016.229 DO - 10.2991/iccte-16.2016.229 ID - Wang2016/01 ER -