Optimization of Drawbead Resistance Based on Orthogonal Experiment
Authors
Minghe Zhang, Lianfa Yang
Corresponding Author
Minghe Zhang
Available Online August 2015.
- DOI
- 10.2991/icaemt-15.2015.55How to use a DOI?
- Keywords
- Automobile panel, Orthogonal experiment, Drawbead resistance coefficient, Forming quality, Weighting coefficient.
- Abstract
The impact of drawbead resistances on the stamping process of an automobile panel was investigated based on orthogonal experiment. Simulations based on Dynaform were conducted and two optimal objects that the maximum ratio of thickness reduction (MRTR) and average thickness in deformation region (ATDR) are extracted from simulation results. Optimal drawbead resistances in different weighting coefficients of the two objects have been found. Appropriate weighting coefficients are obtained by verification simulations. The results provide guidance to the practical fabrication.
- Copyright
- © 2015, the Authors. Published by Atlantis Press.
- Open Access
- This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).
Cite this article
TY - CONF AU - Minghe Zhang AU - Lianfa Yang PY - 2015/08 DA - 2015/08 TI - Optimization of Drawbead Resistance Based on Orthogonal Experiment BT - Proceedings of the 2015 International Conference on Advanced Engineering Materials and Technology PB - Atlantis Press SP - 278 EP - 281 SN - 2352-5401 UR - https://doi.org/10.2991/icaemt-15.2015.55 DO - 10.2991/icaemt-15.2015.55 ID - Zhang2015/08 ER -