Analysis of Roll Equivalent Crown of CVC-6h Mill
- DOI
- 10.2991/ic3me-15.2015.282How to use a DOI?
- Keywords
- tandem cold rolling mill, finite element model, limit specification, shape control, roll equivalent crown
- Abstract
The 2180 mm tandem cold rolling mill is one of the widest cold mills in the world, and it improves the output and production efficiency largely, but some problems puzzle the production such as shape problems of strip, especially the limit width specification. In order to solve the problems, it is necessary to redesign the intermediate roll contour. However, the 2180 mm mill is a six-roll mill, and the intermediate roll adopts CVC contours, and the strip does not contact the CVC contour directly. The roll equivalent crown of the CVC contour can not be used after calculation. It is necessary to study the corresponding relationship between roll equivalent crown and strip crown of the ultra-wide mill. The finite element simulation model (FEM) is built with the MSC.Marc software. Through using the model, the corresponding relationship between roll equivalent crown and strip crown is analyzed, the result shows that the needed crown of work roll is the minimum, however, the needed crown of backup roll is the maximum in order to roll the strip which is same strip crown and approximate same cross section shape, and the effect of roll crown used in different rolls exists a relationship between each other.
- Copyright
- © 2015, the Authors. Published by Atlantis Press.
- Open Access
- This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).
Cite this article
TY - CONF AU - Guang-Hui Yang AU - Jie Zhang AU - Jian-Guo Cao AU - Zhen-Ning Xie PY - 2015/08 DA - 2015/08 TI - Analysis of Roll Equivalent Crown of CVC-6h Mill BT - Proceedings of the 3rd International Conference on Material, Mechanical and Manufacturing Engineering PB - Atlantis Press SP - 1467 EP - 1471 SN - 2352-5401 UR - https://doi.org/10.2991/ic3me-15.2015.282 DO - 10.2991/ic3me-15.2015.282 ID - Yang2015/08 ER -